48
While performing, the CC Pedal= command can be used to assign a
different Continuous Controller number to the CC Pedal (defaulted to
CC 4 at the factory). Upon hitting the assigned pedal, the CC pedal will
be reassigned from its current controller, number to the new continu-
ous controller number. Hitting the footsitch again will assign the pedal
back to the default CC number. Changing the Program will always
cause the pedal to be assigned to the default CC number.
This function is especially useful if you want to use the CC pedal with a
Program in more than one way. For example, you can control the level
of Delay linked to CC4. Then, in real time, reassign the pedal to CC 10
which will control any Parameter in the Program linked to CC 10 (like a
Reverb level). For more information on how to set up this function, see
page 51. For more information on linking Parameters to CC’s, see
page 51.
MIDI Functions Send Prg: On/Off determines whether or not Program Changes will be
sent out the RP-12 MIDI Out port as you select Programs on the RP-
12. This Parameter is either ON or OFF, but will be ignored if all the
Devices in the Program Send Map are disabled. See page 58 for more
information.
Prg Send Map allows the RP-12 to act as a MIDI multiplexer for up to
four other devices. Here’s how it works: when you change from the
current Program, or the RP-12 receives a Program Change message
via MIDI, each external device you specify can receive independent
Program Change messages on individual MIDI channels. This feature
can allow you to control up to four separate MIDI devices with the
RP-12.
You may map as many of the Program changes as you like. These are
stored in memory automatically, and are always active until you
change them or until the factory presets are restored. For more infor-
mation on how to set up this function, see page 58.
Prg Rcv Map allows you to map incoming Program Change commands
(1-128) to any Program on the RP-12. For example, suppose you want
to access Program #146 using a MIDI Program Change command.
Since MIDI only supports Program Change numbers 1 - 128, Program
Change #146 would normally be impossible for the RP-12 to recog-
nize. With the RP-12’s flexible MIDI input mapping, however, you can
assign a Program Change number to be received as Program #146 on
the RP-12. For more information on how to set up this function, see
page 58.
The MIDI Merging option allows incoming MIDI data to be merged with
any MIDI data generated by the RP-12 before being sent to the MIDI
Out port. This is a simple ON or OFF option. See page 65 for more
information.
Section 5 - RP-12 Functions
RP-12 Owner’s Manual
To Next Page
Loading...
Need help?
General
