43
quietest status. The Parameters are as follows:
Effect On / Bypass ........Turns the Module on or off. When Modules are
turned off, their Parameters disappear from the
Parameter menu. To see the Parameters, you
must turn the Module on.
NG Threshold................Sets the level at which the gate will open.
Ranges from -∞ to +∞.
NG Hold Time ...............Controls the amount of time the signal must
remain below the off-threshold before NG
RELEASE TIME begins. This control should
be set long enough to prevent false triggering
during long decay times. Ranges from 0 to 500
milliseconds.
NG Attack Time.............Controls the how fast the gate opens after
detecting a signal above NG THRESHOLD.
Large numbers yield slower attack times, while
small numbers give a fast attack. Varies from
0 to 2000 milliseconds (2 seconds).
NG Release Time..........Controls how fast the gate closes after the sig-
nal has fallen below NG THRESHOLD for the
amount of time set by NG HOLD TIME. Large
numbers yield slow release times, while small
numbers give a fast release. Varies from 0 to
2000 milliseconds (2 seconds).
NG Attenuation..............Sets the amount of attenuation (signal reduc-
tion) when the gate is closed. Varies from 100
dB (eliminates the signal completely) to 0 dB
(no attenuation).
NG Delay Time..............Allows placement of a slight delay on the
source signal after the gate is triggered. This
Parameter allows source material with a very
fast attack time to be heard in its entirety with-
out the lag in gate response that is common to
inferior noise gates. Variable from 0 to 10 mil-
liseconds.
DSP Level DSP Level .....................Controls the overall signal fed to the digital
section. Variable from 0 to -100.
Wahs Effect On / Off ...............Turns the Module on or off. When Modules are
turned off, their Parameters disappear from the
Parameter menu. To see the Parameters, you
must turn the Module on.
Section 4 - Effects and Parameters
RP-12 Owner’s Manual
To Next Page
Loading...
Need help?
General
