37
the detuned note is heard.
NOTE: The dual detuner has a predelay for
each detune voice.
Detune Amount .............Controls the amount of detuning. Variable, in
cents, from -100 to +100.
Whammy™ Whammy On / Off .........Turns the Module on or off. When Modules are
turned off, their Parameters disappear from the
Parameter menu. To see the Parameters, you
must turn the Module on.
Whammy Function ........Selects the function of the Whammy Module.
There are 16 individual functions controlled by
the CC Pedal available in regular Whammy
Modules. They are as follows: ShallowDetune,
DeepDetune, 1 Octave Above, 2 Octaves
Above, 2nd Below, 1 Octave Below, 2 Octaves
Below, 2ndAbv- 3Abv, min3Ab-maj3Ab,
3rdAbv-4thAbv, 4thAbv-5thAbv, 5thAbv-
6thAbv, 5thAbv-7thAbv, 4thBlw-3rdBlw,
5thBlw-4thBlw, and 12Below-12Abv.
NOTE: The Smooth Whammy (Whammy2)
functions are the same, but have slightly differ-
ent names.
Whammy Pedal.............The WHAMMY PEDAL Parameter reflects the
current setting of the continuous control device
used to control the whammy effect. This
Parameter can be modified using the RP-12’s
CC pedal, or manually modified using the
<UP/DOWN> Parameter switches. As the
Parameter is modified, the pitch of the original
note will change in intervals according to the
setting of the WHAMMY FUNCTION. Varies
from 0 to 100.
Arpeggiators Arpeggiator On / Off......Turns the Module on or off. When Modules are
turned off, their Parameters disappear from the
Parameter menu. To see the Parameters, you
must turn the Module on.
Arpeggiator Level..........Controls the overall level of the arpeggiator.
Variable from 0 to 100.
Arpeggio Shift................Sets the interval between the original note and
the shifted note. Variable from -24 to +24 (4
octaves).
Section 4 - Effects and Parameters
RP-12 Owner’s Manual
To Next Page
Loading...
