40
Flange Level..................Controls the overall level of the flange.
Variable from 0 to 100.
Flange Delay.................Sets the amount of delay present in the flange
effect. Varies from 0 to 60.00 milliseconds.
Flange Feedback ..........Controls the amount of flanged sound fed back
to the input of the Module. High regeneration
settings produce dramatic and interesting
unnatural sounds. Varies from -99% to +99%.
This Parameter can also be turned off.
Flange Speed................Controls the speed of the flange sweep.
Variable from 0.06 to 16.00 Hz.
Flange Depth.................This Parameter sets the sweep depth (intensi-
ty) of the flange. Variable from 0.00 to 30.00
milliseconds.
Flange Waveform..........Same as CHORUS WAVEFORM.
Phasers The Phaser produces animated, “swirling” type effects, it takes a nor-
mally flat sound of an instrument and makes it interesting. Phasers
also provide that “surround sound” type of ambience.
Phaser On / Off.............Turns the Module either on or off. When
Modules are turned off, their Parameters dis-
appear from the Parameter menu. To see the
Parameters, you must turn the Module on.
Phaser Level .................Controls the overall level of the phaser.
Variable from 0 to 100.
Phaser Regenertn.........Controls the amount of phased sound fed back
to the input of the Module. High regeneration
settings produce dramatic sounds. Varies
from -99% to +99%. This Parameter can also
be turned off.
Phaser Speed ...............Controls the speed of the phase sweep.
Variable from 0.06 to 16.00 Hz.
Phaser Depth ................This Parameter sets the sweep depth (intensi-
ty) of the phaser. Variable from 0 to 100.
Phaser Waveform .........Same as CHORUS WAVEFORM.
Tremolos Tremolo was one of the first real “effects”, and appeared mostly on
early guitar amplifiers. Because of this, tremolo is sometimes per-
ceived as sounding “old” or “vintage”. The RP-12, however, breathes
Section 4 - Effects and Parameters
RP-12 Owner’s Manual
To Next Page
Loading...
Need help?
General
