50
Pedals The ¡Pedals option allows different functions to be assigned to
each of the pedals on the pedalboard.
• From Program mode, press the <UTILITY> button once.
• Press the Function button <MOD ¡> once. The display reads:
•Press Function button <MOD ¡> again. The display reads:
There are 25 Banks available, each with 10 pedal assignments. As
you scroll through the Banks or Pedals, you will notice the pedal
assignment name and number located under option
£[assignment] change according to each ™Pedal #.
Use Function button <MOD ¡> to select the ¡Bank # option and
scroll to the desired Bank. Function button <MIX ™> selects the
™Pedal # option and allows you to scroll to the desired pedal in
that bank.
Pedal Assignments
There are seven types of pedal assignments. They are: Program
Changes, Program Up/Down, List Up/Down, Bank Up/Down, Toggle
CC (0-127), and CC Pedal (0-127). For a description of these func-
tions, refer to the RP-12 Functions section (pg 46).
Use Function button <MORE £> to select the £[assignment]
option. At this point, press the <UP> and <DOWN> Parameter buttons
to ascend or descend through the RP-12’s Program numbers until you
reach Program 256 . If you continue to press the Parameter buttons,
other assignments will be available in the following order:
£Program Up, £Program Down, £List Up, £List
Down,, £Bank Up, £Bank Down, £Toggle CC 0-127,
£CCPedal= CC 0-127.
¡Bank 1 ™Pedal 1
£[assignment] 1
¡Pedals ™CC Ped
£PrgList Assign≥
Section 6 - Pedalboard Set-Up
RP-12 Owner’s Manual
To Next Page
Loading...
Need help?
General
