©2012 Digitrax, Inc. www.digitrax.com 51
26.0 Clearing the System
Some users prefer to “dispatch” or release all addresses active in their system
before shutting down. This can prevent unexpected results when you power up
the layout again.
To release/dispatch addresses (this is optional):
1. Press the ## key.
2. Enter the loco address on the numeric keypad. The display will flash the
FUNCTION Indicator Dot and the loco address. Press the ## key
again.
3. Set the Throttle Knob to '(#$.
4. Press the ,( key.
5. Repeat for all locos/addresses used in your session.
To Shut Down the System:
1. Press the Power Key to turn track power off.
2. Unplug the PS314 from the wall.
To Next Page