To Next PageTo Next Page
Need help?Do you have a question about the Digitrax Zephyr xtra and is the answer not in the manual?
Provides initial steps to get the system up and running.
Details connecting track wires to DCS51 and plugging in the power supply.
Explains how to turn on track power using the POWER key and TRACK STATUS light.
Steps to select and operate an analog locomotive using address "00".
Steps to select and operate a DCC locomotive with factory address "03".
Provides simple instructions for connecting track and power supply to get started.
Step-by-step guide to operating an analog locomotive using address "00".
Steps to select and operate a DCC locomotive with a known address.
Provides basic troubleshooting steps for issues encountered during setup.
Introduction to CVs and programming methods (Service Mode, Operations Mode).
Details on using PROG A & B outputs to set up a programming track.
Step-by-step guide to changing and reading locomotive decoder addresses.
How to program CVs for functions like acceleration and deceleration.
How to program decoders using Operations Mode (OPS) on the main layout.
Explains common error messages encountered during programming.
How to read back programmed CV values from decoders using a programming track.
How to operate functions F0 through F9 using the DCS51 keypad.
Steps to resolve issues when locomotive functions do not respond.
Step-by-step guide to linking locomotive addresses for MU operation.
How to unlink a locomotive address from an MU.
Explains the "stealing" feature to take control of a loco from another throttle.
Describes various error messages like short circuit, current overload, and overvoltage.
Troubleshooting bad connections and poor wheel pickups.
How to stop the layout immediately using the POWER key.
Steps to take when a decoder is not responding to commands.
How to customize DCS51 operations using option switches.
General| Brand | Digitrax |
|---|---|
| Model | Zephyr xtra |
| Category | Remote Control |
| Language | English |
