Chapter6 File Server
This chapter describes the file server function of the Server which allows USB storage
devices to be shared across a network by using SMB: NetBIOS over TCP/IP and FTP
protocol.
6.1 Preliminary
1. This product supports a file format of FAT12/16/32 and NTFS. However, the
“write” operation on NTFS is only supported in NetUSB mode. Please refer to
the Storage Access Mode.
2. Digitus Corporation is not responsible for the loss or corruption of data in
memory devices, including hard disk; Digitus is not responsible for the leak,
manipulation, loss, or corruption of data in memory devices connected to the
Server after unauthorized access.
3. In order to use the USB Mass Storage device connected to the Server, the SMB
protocol or FTP protocol must be set up.
4. This product does not support to magnet optical drive devices such as CD/DVD.
5. This product allows shared two USB storage devices over the network in
Windows through the USB ports.
6. This product does not support the USB devices through USB hub.
6.2 Storage Names
The local drives of the two storages in USB1 port and USB2 port are named as
USBx_DxPx, where USBx represents the USBx port, Dx represents the the x-th Disk
and Px represents the x-th partition.
6.3 Connecting USB Mass Storage to the Server
45
The Server
Storage
LAN HUB/Switch
To Next Page
Loading...
