Chapter13 Restore Factory Defaults
You may restore the Server’s default parameters by one of the following methods.
13.1 Using the Control Center
1. Start the Control Center.
2. If the tool finds Servers in your local area network, then you have to select a
Server from the Server List.
3. Double click the highlight list and enter the Server’s administrator (default:
admin) and password (default: admin).
4. After you have logged in successfully, from the Server menu, select
Maintenance. The Maintenance dialog appears.
5. Click Factory Default.
13.2 Using the Server’s Web Pages
1. Go to the Server’s web page and click CONFIG
2. Enter administrator (default: admin) and password (default: admin).
3. Click Maintenance.
4. Click Factory Default.
5. Click Yes to confirm
13.3 Using Init Button
Plug in the power adaptor while pressing the Init button until LED indicators of Power,
USB1 and USB2 blink. After that, plug off the power adaptor and then plug in the
power adapter again to restart the Server. Finally, the Server will operate using the
Factory Default values.
81
To Next Page
Loading...
