Chapter15 The Init Button
The Init button is used for maintenance: Simultaneously press Init button and turn
on (by plugging in the power adaptor) the Server until USB1 and USB2 LED indicators
simultaneously blink. (For DN-13018, only USB1 LED indicator will blink.) After that,
the Server will do the following tasks:
A. Perform a Factory Default of the MFP server, which will restore most of the
parameters and settings to factory default values,
B. Perform a TFTP server. You can upgrade new firmware using any TFTP client tool.
Note: After performing the tasks mentioned above, you have to plug off the power
adaptor and then plug in the power adaptor to restart the Server.
87
To Previous Page
Loading...
