19 / 38
You’ll be prompted to input connection parameters for the wireless access
point you wish to connect:
Required parameters are:
Profile name
You can give a name to this profile, so you can
remember its purpose easily. It can be any phrase
to help you remember.
Network Name (SSID)
The SSID (Service Set IDentifier, i.e. access point’s
name). This must be identical with the SSID of the
access point you wish to connect.
This is a
computer-to-computer
(ad hoc) network
Check this box if you wish to connect to another
computer / network device by ad hoc method.
When not accessing to wireless access point, you
have to check this box.
Channel
Select wireless channel for ad hoc connection. This
option only appears when you’re using ad hoc
connection.
Network Authentication
Select the network authentication type from
drop-down menu. This setting must be identical
with the setting of wireless access point you with to
connect.
Data encryption
Select the data encryption type from drop-down
menu. This setting must be identical with the setting
of wireless access point you with to connect.
ASCII / PASSPHRASE
When the encryption type is ‘WEP’, it’s required to
input a set of ‘passphrase’ to connect to wireless
access point. Check ‘ASCII’ or ‘PASSPHRASE’
To Next Page
Loading...
Need help?
General
