Dimension One Spas Executive - Page 20

Page 16
Reflections Collection
CAUTION: TO DECREASE BUILD UP ON COMPONENTS AND
MINIMIZE ACRYLIC DAMAGE. Neverllwithwaterfromawater
softener.Ifyourwaterisextremely“hard,”itispreferabletollhalf-
way with hard water and the rest of the way with softened water.
Water that is too soft can be corrosive to metal components.
•
!
WARNING: TO DECREASE RISK OF INFECTION OR
DISEASE.
Fill hot tub with clean tap water from garden hose, to reduce risk of
contracting a waterborne illness (e.g. an infection, bacteria or virus)
and/or respiratory ailments . Fill the spa until the water level is about
6" below the top of the spa. (DO NOT OVERFILL!).
IMPORTANT:Alwaysllyourhot tubthroughbothlterttings
after draining. Failure to do so may cause air to be trapped in the
pumps, preventing them from circulating water.
3. Turn On Power
 Turnonpowertohottubatthehome’scircuitbreaker.Thelter
pumps will turn on for one minute each to blow out the plumbing
lines, page 21. Then the heater and circulation pump will
automatically activate. Activate Jets Pump 1 to prime the pump,
page 23. Let it run for about 10-15 seconds. Repeat this process
with all the pumps. Once, all the pumps are primed, cleared of
airlocks,andtherearenoowerrors,reinstalltheltercartridges
and close the air bleeder caps.
4. Add Start-Up Chemicals
Turn on the jet pumps when adding chemicals in order to circulate
the chemicals thoroughly. Add the hot tub water chemicals as
recommended by your authorized hot tub dealer. See Section titled
“Water Quality Maintenance” for general guidance.
WARNING: RISK OF POISONING OR DEATH.
Never leave chemicals opened and accessible to anyone. Use
chemicals according to the vendor’s instructions. Always store
chemicals in a safe and/or locked location. Keep away from
and out of reach of children.
!
5. Establish A Stable Sanitizer Reading
Establish a stable sanitizer reading of no less than 3.0-4.0 ppm free
chlorine or 2.0-4.0 ppm bromine. To ensure healthy water conditions,
always maintain a constant sanitizer reading within the levels
recommended by the Association of Pool and Spa Professionals. If
sanitizer levels cannot be stabilized, perform the decontamination
procedure steps 8-14 on the following page.