Dimension One Spas Executive - Protective Conditions;Error Messages

Page 45
Reflections Collection
14.4 Other Additives
Many other additives are available for your hot tub. Some are necessary
to compensate for out-of-balance water, some aid in cosmetic water
treatment and others simply alter the feel or smell of the water. For
specicguidance,onmaintainingwaterquality,consultyourauthorized
dealer who can recommend the appropriate chemical products.
15.0 Protective Conditions/Error Messages
There are a number of unique functions designed into your D1 hot tub to
protect it from damage and/or to aid in troubleshooting. The error indica-
tor as well as a screen will notify you when the hot tub needs imme-
diate attention. Following is a listing of all the possible messages along
with their meanings. Always insist on genuine Dimension One Spas
replacement parts.
Code Description
HL
High Limit circuit has tripped. This must be repaired only
byaqualiedauthorizedserviceorganizationorservice
technician.
FLO
• Noowconditionformorethan2hours.Contactyour
authorized dealer or service organization.
• Noowcondition“HRA”hardwareerrorwas
detected (relay stuck). Contact your authorized
dealer or service organization.
OH
DO NOT ENTER THE WATER! Spa temperature
is too high. Contact your authorized dealer or service
organization.
WARNING: RISK OF HYPERTHERMIA (OVER-
HEATING) CAUSING SEVERE INJURY, BURNS,
OR WELTS.
Pr
Temp probes or detection circuit are defective. This
mustberepairedonlybyaqualiedauthorizedservice
organization or service technician.
AOH
Elevated internal temperature. Controller temperature has
exceeded acceptable limits. If condition persists, provide
shade for equipment side of spa. Contact your authorized
dealer or service organization.
!