Dimension One Spas Executive - Hot tub Fill Up Procedure

Page 15
Reflections Collection
7.0 Power Requirements
7.1 North American 240V 60Hz Models
Model Power Branch Circuit
Circuit
Protection
Wire
Gauge
Reections
Collection
240V
3 wires + Ground
30A #6 awg
240V 40A #6 awg
240V 50A
* #6 awg
*Recommended power requirements for the Executive Model
7.2 Export 230V 50Hz Models
Model Power Circuit Protection
Reections
Collection
230V
1 x 32A
2 x 16A
3 x 16A
8.0 Hot tub Fill Up Procedure
For best results, read each step in its entirety before proceeding with this
procedure. Make sure all drains are closed before you begin.
IMPORTANT NOTICE: Make sure to install the
drain hose bib, that is packaged in the warranty pack,
on to the hot tub. Securely screw in and close the drain
valve and drain cap.
1. Prepare The Hot tub For Filling
• Clear all debris from the hot tub. (Although the hot tub
shell has been polished at the factory, you may want
to treat it with a specially formulated hot tub cleaner.) Consult your
authorized Dimension One dealer for additional information prior to
llinghottub.
• RemovetheltersasillustratedinSection13.1
CAUTION: Do not leave the spa shell exposed to the sun during
thellingprocess.Leavingitexposedcouldresultinsurfacedam-
age and not covered under the warranty.
2. Fill Hot tub
• Place the end of your garden hose into one of the empty skimming
ltertting.Removebothoftheairbleedercapstoallowtheairto
escapeasthehottublls,page20. Fill hot tub half way, then
placethegardenhoseintotheoppositelterttingwhileaddingthe
remainingllwater.
Figure 8.0a