Page 38
Reflections Collection
13.0 Hot tub Maintenance
Proper and regular maintenance of your hot tub will help it retain its
beauty and performance. Your authorized Dimension One Spas dealer
can supply you with all the information, supplies, and accessory products
you will need to accomplish this.
!
DANGER: RISK OF SEVERE INJURY OR DROWNING
BY ENTRAPMENT!
• Keep hair, loose articles of clothing or hanging jewelry away
fromsuctionttings,rotatingjetsorothermovingcomponentsto
avoid entrapment that could lead to drowning or severe injury.
• Neverusethehottubunlessallsuctionguards,lter,lterlid,
or skimmer assembly are installed to prevent body and/or hair
entrapment.
• Neveroperateorusethehottubifthelter,lterlid,orskimmer
assembly are broken or any part of the skimmer assembly is
missing. Please contact your dealer or nearest service center
for service.
• Thesuctionttingsandsuctioncoversinthishottubaresized
tomatchthespecicwaterowcreatedbythepump(s).Ifit
isnecessarytoreplacethesuctionttings,suctioncoversor
pump(s),besurethattheowratesarecompatibleandarein
compliance with the VGB Safety Act, page 2.
• Neverreplaceasuctionttingorsuctioncoverwithonerated
lessthantheowratemarkedontheoriginalsuctiontting.
Usingimpropersuctionttingsorsuctioncoverscancreate
a body or hair suction entrapment hazard that may lead to
drowning or severe injury.
• Owners must alert all hot tub users to the potential risk of Hair,
Limb, Body, Evisceration (disembowelment), and Mechanical
Entrapment, page 6.
13.1 Cleaning the filters
IMPORTANT: To prevent debris from getting into the system during
ltercleaning,D1recommendsthatyoushutoffthepoweratthe
GFCI or enter “Standby Mode” – outlined in the Settings section of
this manual.
A. Cleaning the Filter Cartridges
Yoursystemhastwolters.Toremoveandcleanthelters,follow
thesesteps.Werecommendthatyoucleantheltersonceamonthas
preventativemaintenance.Everyothercleaning,soaktheltersinlter
cleaning solution and rinse thoroughly.
1. Turn the breaker, to the hot tub, OFF or put the hot tub in “Stand
By” mode!
2. Accessthelterundertheskimmerbasket,Figure13.1a,liftthe
centeroatofftheskimmerassemblyuntilfullyextended.Turn
counterclockwiseuntiltheatsofthebasketlineupwiththesecuring
tabs. Pull the assembly straight up to remove, Figure 13.1c.