Dimension One Spas Executive - Operating the Dynamic Massage Sequencer (on Select Models)

Page 29
Reflections Collection
11.15 Operating the Dynamic Massage Sequencer (On select mod-
els)
To operate the massage sequencer, follow these steps.
1. Press the Jets button to turn on the jet pump.
2. Continually press the Sequence button to select one of the six
massage options.
3. Press the Speed button to select the one of the three options.
4. Press the Start/Stop button to begin the sequence.
Sequence 1: Steps through each individual zone one at a time, from
zone A through F, then reverses the sequence.
Sequence 2: Activates all zones at once, then deactivates individual
zones one at a time, from A through F. Then it reverses
that sequence.
Sequence 3: Activates alternate groups of zones. It activates Zones A,
C, and E all at once, then switches to Zones B, D, and F.
Sequence 4: Steps through each individual zone one at a time, from zone
A through F, then it starts over in groups of two zones –
activating zones A and B, then zones B and C, etc.
Sequence 5: Starts with Zone A and adds new zones one at a time until
all zones are active. Then it reverses the sequence by
removing zones one at a time until all zones are inactive.
Sequence 6: Activates random pairs of zones at one time, starting
with adjacent zones, (A and B, then B and C, etc.), then
oppositezones(AandF,thenBandF,etc.),andnallythe
middle zones (B and E, then C and D, etc.).