10
directly on carpet or similar surfaces which may restrict air
circulation. If installing the fireplace in a carpeted area, place a
one-piece, solid, flat surface under the fireplace insert. Ensure that
all three (3) of the insert’s feet rest securely on this surface.
For Bathroom Use
If this unit is installed in a bathroom it must be protected by a GFI
receptacle or circuit. If receptacle is used it must be readily accessible.
To prevent electrical shock this unit is an electrical appliance that is not
watertight and must be installed as to prevent water from entering unit.
This must be installed away from showers, tubs, etc. Never locate
fireplace where it may fall into a bathtub or other water container. High
temperatures may be generated under certain abnormal conditions.
Do not partially or fully cover or obstruct the front of this heater.
Operation
Electric Fireplace Manual Controls
The manual controls for the fireplace are behind the access panel
located at the bottom of the fireplace (Figure 6).
A. Heat On/Off Switch
Turns heat on or off.
B. Flame Action Control
Turn the flame action control knob to adjust the flame speed to the
desired level.
B
Figure 6
CADE
To Next Page
Loading...
Need help?
General
