WARNING
Ensure the power cord is not installed so that it is pinched or against any sharp edges and
ensure that the power cord is stored or secured to avoid tripping or snagging to reduce the risk
of fire, electric shock or injury to persons.
Electrical outlet wiring must comply with local
building codes and other applicable regulations to reduce the risk of fire, electric shock and
injury to persons.
Do not attempt to wire your own new outlets or circuits. To reduce the risk of fire, electric
shock or injury to persons, always use a licensed electrician.
Site Selection and Preparation
This section provides instructions for selecting a location and preparing the site to install the
fireplace into your Dimplex mantel surround.
1. Select a suitable location that is not susceptible to moisture and is away from drapes,
furniture and high traffic.
2. For ease of electrical hook up you may wish to locate the fireplace near an existing
outlet. (refer to NOTE 1)
3. Store the fireplace in a safe dry and dust free location.
CAUTION
Clearance for air circulation beneath the fireplace is provided by two spacers. DO NOT
INSTALL FIREPLACE DIRECTLY ON CARPET OR SIMILAR SURFACES WHICH MAY
RESTRICT AIR CIRCULATION. If installing the fireplace in a carpeted area, place a one-
piece, solid flat surface under the fireplace. Ensure that all feet rest securely on this surface.
NOTE
The dimensions of the fireplace are 27.35” wide X 23.465” high X 8.75” deep. The fireplace
does not require any additional venting.
To Next Page
Loading...
Need help?
General
