Dimplex BLF5051 - Front Glass Installation

15
Fireplace Installation
circuits. To reduce the risk of re,
electric shock or injury to persons,
always use a licensed electrician.
WARNING: Ensure that the
circuit on which the replace is to
be installed has the power cut off
at the service panel until installa-
tion is complete.
3. Lift replace and insert into
opening. The replace's
mounting trim should be ush
against the wall (Figure 13).
4. Use bubble level (supplied) to
level the replace within the
framing. Adjust as required.
5. Drive four supplied mount-
ing screws through the four
mounting holes located on the
inside surface of the replace
chassis, into wall studs (Figure
13).
6. Refer to Front Glass Installa-
tion section for nal installation
procedures.
Front Glass Installation
1. Evenly distribute supplied
glass rock on the front tray of
the fireplace (Figure 14).
2. Carefully mount front glass as-
sembly so that the front glass
hooks (4) hang on the front
glass mounts on the fireplace
(4) (Figure 15).
3. Use the supplied two Phillips
sheet metal screws to fasten
Figure 14
Front tray
Front glass
assembly
Figure 13
Mounting hole
Mounting hole
Wall
surface