16
Little or No Mist
Generation
---
Transducer not operating correctly
Transducer is dirty
Transducer is not sitting correctly
in sump
Fan is obstructed or blocked
Nozzle is not on sump correctly
Nozzle is blocked
Check operation of transducer
Clean sump and transducer thoroughly
Switch off product, take nozzle off sump and
ensure transducer is tted in sump correctly
Remove air lter and clean. Ensure it is
placed back in product correctly.
Ensure Nozzle is sitting on sump correctly
Clean sump, transducer and nozzle thor-
oughly
The ame effect
has too much
smoke.
--- Flame effect setting is too high
Turn down the ame effect. Give the product
time to adjust to the new setting
Bluetooth Receiv-
er stops working
---
Loose connection Check connection to jack (Fig 12)
Remote Control
stops working
---
Bluetooth range issue
Bluetooth Receiver connection is
loose
Remote control batteries need
replacing
Check positioning of Bluetooth Receiver.
Ensure it is not encased in metal or concrete.
Check connection to jack (Fig 12)
Replace batteries with two new AAA batteries
To Next Page
Loading...
