Dimplex Ignite XLF50 - Maintenance; Cleaning Partially Reflective Glass; Cleaning Fireplace Surfaces; Authorized Servicing

5
Maintenance
 WARNING: Disconnect power and allow heater to
cool before attempting any maintenance or cleaning to
reduce the risk of re, electric shock or damage
to persons.
!
NOTE: The replace should not be operated with an
accumulation of dust or dirt on or in the unit, as this
can cause a build up of heat and eventual damage.
For this reason the heater must be inspected regularly,
depending upon conditions and at least at yearly
intervals.
Partially Reective Glass Cleaning
The partially reective glass is cleaned in the factory during
the assembly operation. During shipment, installation,
handling, etc., the partially reective glass may collect dust
particles; these can be removed by dusting lightly with a
clean dry cloth.
To remove ngerprints or other marks, the partially
reective glass can be cleaned with a damp cloth. The
partially reective glass should be completely dried with a
lint free cloth to prevent water spots. To prevent scratching,
do not use abrasive cleaners.
Fireplace Surface Cleaning
Use only a damp cloth to clean painted surfaces of the
replace. Do not use abrasive cleaners.
Servicing
Except for installation and cleaning described in this
manual, an authorized service representative should
perform any other servicing.