Dimplex RLG20BR - Operation

3
Power
Press to activate the current standby state (On/O󰀨).
• Standby State On
Press to turn everything O󰀨. Press again to active the
previous ame e󰀨ect state.
• Standby State O󰀨
Press to activate the previous ame e󰀨ect state.
- If the ame e󰀨ect was On, the previous heat setting
will be activated (High, Low, or O󰀨).
- If the ame e󰀨ect was O󰀨, the previous heat setting
will be activated (High or Low).
Press again to turn everything O󰀨.
Flame
Press to light the back log, grate log, and ember mat
(optional), and start the ame e󰀨ect.
Heat
• Heat On
Press to set the heat to Low (indicated by 1 short
beep). Press again to set the heat to High (indicated
by 2 short beeps).
• Heat O󰀨
Press to turn heat O󰀨 (indicated by 1 long beep).
NOTE: After the heater is switched o󰀨, the fan will
continue on for 60 seconds before turning o󰀨. The log
LEDs remain On when the heater is ON and the ame
e󰀨ect is O󰀨.
360
o
Light
Press multiple times to change the LEDs on the
sides and back of the unit from white ickering to
white solid to O󰀨. (This feature is active only when
the ame e󰀨ect is On.)
Brightness
Press multiple times to toggle the log set LEDs
!
Operation
RLG20
Manual Control
The manual controls for the Revillusion are located on the
right-front leg of the log grate.
Power
Press to turn the ame e󰀨ect on and activate the
previous heat setting (O󰀨, Low, or High). Press again
to put the unit in standby mode.
Heat
• Heat On
Press to set the heat to Low (indicated by 1 short
beep). Press again to set the heat to High (indicated
by 2 short beeps).
• Heat O󰀨
Press to turn heat O󰀨 (indicated by 1 long beep).
NOTE: After the heater is switched o󰀨, the fan will
continue on for 60 seconds before turning o󰀨. The
log LEDs remain On when the heater is ON and the
ame e󰀨ect is O󰀨.
360
o
Light
Press multiple times to change the LEDs on the
sides and back of the unit from white ickering to
white solid to O󰀨. (This feature is active only when
the ame e󰀨ect is On.)
Brightness
Press multiple times to toggle the log set LEDs
through its four brightness settings.
Remote Control
The replace is supplied with a multi-function remote con-
trol.
The remote control has a range of approximately 30 ft (9
m). To operate correctly, the remote control must be pointed
toward the front of the unit.
!