OPERATOR’S MANUAL with Maintenance Information
Maintenance
36
Observe and Obey:
√ Only routine maintenance items specified in
this manual shall be performed by the
operator.
√ Scheduled maintenance inspections shall
be completed by qualified service
technicians, according to the manufacturer's
specifications and the requirements
specified in this manual.
Maintenance Symbols Legend
The following symbols have
been used in this manual to help communicate
the intent of the instructions. When one or
more of the symbols appear at the beginning
of a maintenance procedure, it conveys the
meaning below.
Indicates that tools will be required to
perform this procedure.
Indicates that new parts will be required
to perform this procedure.
Indicates that dealer service will be
required to perform this procedure.
Pre-delivery Preparation Report
The pre-delivery preparation report contains
checklists for each type of scheduled
inspection.
Make copies of the Pre-delivery Preparation
report to use for each inspection. Store
completed forms as required.
Maintenance Schedule
There are five types of maintenance
inspections that must be performed according
to a schedule— daily, quarterly, semi-annually,
annually, and two year. The Scheduled
Maintenance Procedures Section and the
Maintenance Inspection Report have been
divided into five subsections—A, B, C, D, and
E. Use the following chart to determine which
group(s) of procedures are required to perform
a scheduled inspection.
Quarterly or every 250 hours
Semi-annually or every 500 hours
Annually or every 1000 hours
Two year or every 2000 hours
Maintenance Inspection Report
The maintenance inspection report contains
checklists for each type of scheduled
inspection.
Make copies of the Maintenance Inspection
Report to use for each inspection. Maintain
completed forms for a minimum of 4 years or
in compliance with your employer, jobsite and
governmental regulations and requirements.
To Next Page
Loading...
Need help?
General
