DINGLI S036-RS - Maintenance Inspection Reports

OPERATOR’S MANUAL with Maintenance Information
Maintenance
38
Maintenance Inspection Report
Model
Serial number
Date
Hour meter
Machine owner
Inspected by (print)
Inspector signature
Inspector title
Inspector company
Instructions
• Make copies of this report to use for each
inspection.
• Select the appropriate checklist(s) for the
type of inspection to be performed.
□
Daily or 8 hours
Inspection:
A
□
Quarterly or 250 hours
Inspection:
A+B
□
Semi-annually or 500
hours Inspection:
A+B+C
□
Annually or 1000 hours
Inspection:
A+B+C+D
□
Two year or 2000 hours
Inspection:
A+B+C+D+E
• Place a check in the appropriate box after
each inspection procedure is completed.
• Use the step-by-step procedures in this
section to learn how to perform these
inspections.
• If any inspection receives an “N”, tag and
remove the machine from service, repair and
re-inspect it. After repair, place a check in the
“R’ box.
Legend
Y = yes, acceptable
N = no, remove from service
R = repaired
Checklist A
Y
N
R
A-1 Inspect the manuals and decals
A-2 Pre-operation inspection
A-3 Check the Batteries
A-4 Check the Hydraulic Oil Level
A-5 Function tests
Perform after 40 hours:
A-6 30 day service
Checklist B
Y
N
R
B-1 Batteries
B-2 Electrical wiring
B-3 Tires and wheels
B-4 Emergency stop
B-5 Key switch
B-6 Horn (if equipped)
B-7 Drive brakes
B-8 Drive speed - stowed
B-9 Drive speed - raised
B-10 Drive speed - slow
B-11 Hydraulic oil analysis
B-12 Tank venting system
B-13 Slider components
Checklist C
Y
N
R
C-1 Platform overload (if equipped)
C-2 Breather cap - models with
optional oil
Checklist D
Y
N
R
D-1 Scissor arm wear pads
Checklist E
Y
N
R
E-1 Hydraulic oil