Dingo 950 Operation & Maintenance Manual
12
Checking the Oil Level.
Refer to your engine manual.
Remove debris from the machine
IMPORTANT: Overheating will result if the engine is operated with a blocked grass
screen, dirty or plugged cooling fins, and/or cooling shrouds removed.
Park the machine on a flat surface, lower the loader arms and turn off the engine (turn
ignition key to off). Remove the key.
Check the air filter pre-cleaner for debris. If required, wipe away debris before and
during each use.
Debris can build up in the engine area. Clean any debris build-up with a brush or
blower before each use.
IMPORTANT: It is preferable to blow out dirt than to wash it out. If water is used,
keep it away from electrical appliances.
IMPORTANT: Do not high-pressure wash. High-pressure washing can damage the
electrical system.
Check hydraulic fluid
Check the hydraulic fluid level before engine is first started and after every 25 hours
of operation.
Fluid type: H68 or equivalent
Hydraulic tank capacity: 60 litres
Position machine on level surface, lower the loader arms and stop the engine
Clean area around filler neck of hydraulic tank.
Remove cap from filler neck and check fluid level. Fluid level should be to approx.
75-100mm below the top of the tank.
If level is low, add enough fluid to raise to proper level.
Install cap on filler neck.
To Next Page
Loading...
Need help?
General