Dingo 950 Operation & Maintenance Manual
18
Backward
To go backward, slowly pull the drive control levers rearward.
To go straight, apply equal pressure to both drive control levers.
To turn, decrease pressure on the drive control lever closest to the direction you want
to turn.
To slow or stop, move or release the drive control levers into neutral. (If released the
control levers should automatically return to neutral).
Stopping the machine
To stop the machine, move the drive control levers to neutral, lower loader arms to the
ground, and turn the ignition key to “OFF” to stop the engine. Remember to remove
the key from the key switch.
Caution!
If children or bystanders attempt to operate the machine, someone could be injured.
To avoid attempted use by children or bystanders while machine is unattended,
remove the key from the ignition, even if just for a few minutes.
Moving a Non functioning machine
IMPORTANT: Never tow the machine because hydraulic damage may occur.
To Move the Machine
Turn the ignition key to “OFF” to stop the engine.
Lift the entire machine off the ground and move the machine.
Using Cylinder Locks
IMPORTANT: Normal maintenance should be completed with the loader arms
lowered. If maintenance or repairs requires the loader arms raised, use cylinder locks.
Warning!
Loader arms may lower when in the raised position. Anyone under the loader arms
could be injured or crushed. To avoid this hazard always install cylinder locks or a
safety stand. (Contact a Dingo representative if you are unsure).
To Next Page
Loading...
Need help?
General