Dinstar UC2000-VE - General Purpose Commands in Config Mode; Set Time (Clock Set); Save the Configuration (Save); Restart Device (Reset Eia)

UC2000-VE/F/G GSM/CDMA/WCDMA VoIP Gateway User Manual
_______________________________________________________________________________
Shenzhen Dinstar Co., Ltd.
115
5.3.2 GENERAL PURPOSE COMMANDS IN "CONFIG" MODE
Set time (clock set)
Save the configuration (save)
Restart device (reset eia)
Enable debug
The command format is deb port + port number, to enable port 0 debug, as below:
To enable all ports debug, with the command “deb port all”
Without this steps, no trace logs will display on output window