M
Michael WilsonSep 13, 2025
Why Directed Remote Starter waiting to begin the programming sequence?
- TTony ScottSep 14, 2025
Make sure you are following the correct programming procedure.
To Next PageTo Next PageWhy Directed Remote Starter waiting to begin the programming sequence?
Make sure you are following the correct programming procedure.
What to do if Directed Remote Starter transponder functions were skipped?
If compatible and when RXT mode is not desired or convenience features are needed, reset and reprogram the module.
What to do if Directed Remote Starter ISO 1 not detected?
The Yellow/Black wire did not detect the expected signal. Refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
What to do if Directed Remote Starter ISO 2 not detected?
The Orange/Black wire did not detect the expected signal. Refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
What to do if Directed Remote Starter MUX not detected?
The Violet/Green or Violet/Brown wire did not detect the expected voltage value. Refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
Why Directed Remote Starter OBDII feature not supported?
The diagnostic data bus was not detected, therefore the SmartStart features will be limited.
Why Directed Remote Starter PTS shutdown error?
The PTS output from the module was not activated due to safety protection.
What to do if Directed Remote Starter CAN bus incorrectly detected?
Verify the CAN1 and CAN2 connections. Refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
Why Directed Remote Starter Runsafe was not disabled?
No UNLOCK command was received prior to opening the door, or the 45 second timer expired in takeover mode.
Why Directed Remote Starter brake was not detected?
The brakes were not detected, which prevents the system from shutting down the vehicle.
General| Brand | Directed |
|---|---|
| Model | Directechs DB3 |
| Category | Automobile Accessories |
| Language | English |
Lists all functions compatible with the vehicle for installation.
Presents an alternative wiring diagram for the DB3 module installation.
Shows alternative locations of key components within the vehicle for installation.
Lists error codes indicated by LED flashes during module programming.
Addresses troubleshooting for OBDII features and external module sync issues.
Explains LED feedback for lock, unlock, trunk, and auxiliary commands received.
Lists LED indicators for various reasons of remote start unscheduled shutdown.
Explains LED indicators for Remote Start Ready (RSR) specific error conditions.
Describes methods to send commands like lock, unlock, and remote start.
Explains the "Get In and Go" feature for seamless takeover after remote start.
Explains the functionality and benefits of the SmartStart mobile application for vehicle control.
