G
Glenn RobinsonSep 15, 2025
Why Directed Remote Starter smart key was not detected?
- JJessica CaldwellSep 15, 2025
The smart key was not detected, which prevents the system from shutting down the vehicle.
To Next PageTo Next PageWhy Directed Remote Starter smart key was not detected?
The smart key was not detected, which prevents the system from shutting down the vehicle.
Why Directed Remote Starter speed was detected?
The vehicle was detected as moving, which prevents the system from shutting it down.
Why Directed Remote Starter RFTD disabled?
3x OEM Lock Remote Start Activation was attempted when the RFTD feature is disabled. Make sure 3x Lock Start is selected from the web in the flashing process.
What to do if Directed Remote Starter feature error?
An RSR feature file mismatch was detected. Please contact Technical Support.
What causes bypass processing error in Directed Directechs DB3 Automobile Accessories?
If you encounter a bypass processing error with your Directed Automobile Accessories, reset the module and try again. If the condition persists, please contact Technical Support.
Why is CAN bus incorrectly detected in Directed Directechs DB3?
If the CAN bus is incorrectly detected by your Directed Automobile Accessories, verify the CAN1 and CAN2 connections. Refer to 'Installation (wiring diagrams & vehicle wiring reference charts)' to check the connections.
What does it mean if OBDII feature is not supported in Directed Directechs DB3?
If the OBDII feature isn't supported in your Directed Automobile Accessories, it means the diagnostic data bus wasn't detected, which will limit the SmartStart features.
Why is RFTD disabled in Directed Automobile Accessories?
RFTD is disabled in your Directed Automobile Accessories because 3x OEM Lock Remote Start Activation was attempted when the RFTD feature is disabled. Make sure 3x Lock Start is selected from the web in the flashing process.
How to troubleshoot Directed Automobile Electronics module with no power?
If your Directed Automobile Electronics module isn't getting power, ensure the D2D harness is properly connected and that there's 12V present between the red and black wires. If the voltage is correct, the module itself might be defective.
What to do if bypass data is not detected in Directed Automobile Electronics?
If the bypass data isn't being detected by your Directed Automobile Electronics, check the connection of the bypass line. If multiple wires are used, ensure they're not inverted. Also, verify that the vehicle still operates correctly with the factory key.
General| Brand | Directed |
|---|---|
| Model | Directechs DB3 |
| Category | Automobile Accessories |
| Language | English |
Lists all functions compatible with the vehicle for installation.
Presents an alternative wiring diagram for the DB3 module installation.
Shows alternative locations of key components within the vehicle for installation.
Lists error codes indicated by LED flashes during module programming.
Addresses troubleshooting for OBDII features and external module sync issues.
Explains LED feedback for lock, unlock, trunk, and auxiliary commands received.
Lists LED indicators for various reasons of remote start unscheduled shutdown.
Explains LED indicators for Remote Start Ready (RSR) specific error conditions.
Describes methods to send commands like lock, unlock, and remote start.
Explains the "Get In and Go" feature for seamless takeover after remote start.
Explains the functionality and benefits of the SmartStart mobile application for vehicle control.
