To Next PageTo Next PageWhat to do if CAN1 is not detected in Directed Automobile Electronics?
If CAN1 isn't being detected, check the connections of the Tan and Tan/Black wires. Try waking up the data bus by turning the ignition on and attempting the process again. If your setup doesn't need this connection, you can skip it by pressing the programming button 5 times.
What to do if CAN2 is not detected in Directed Automobile Electronics?
If CAN2 isn't being detected, check the connections of the Orange/Green and Orange/Brown wires. Try waking up the data bus by turning the ignition on and trying again. If your installation does not require this connection, skip this step by pressing the programming button 5 times.
What to do if J1850 is not detected in Directed Automobile Electronics?
If J1850 isn't being detected, check the J1850 wire connection. Wake up the data bus by turning the ignition on and try again.
What to do if initialization failed on Directed Automobile Electronics?
If the initialization process fails, reset the module and try the programming procedure again.
What to do if Directed Automobile Electronics shows a bypass processing error?
If you encounter a bypass calculation failure, reset the module and try again.
What to do if Directed Automobile Electronics is waiting to begin the programming sequence?
If the module is stuck waiting to begin the programming sequence, make sure you're following the correct programming procedure.
Why Directed Automobile Electronics runsafe was not disabled?
The runsafe feature wasn't disabled because no UNLOCK command was received before opening the door, or the 45-second timer expired in takeover mode.
What to do if Directed Door locks bypass data not detected?
Check the bypass line connection. If multiple wires are used, ensure they aren't inverted. Also, verify that the vehicle still operates correctly with the factory key.
Why is the OBDII feature not supported on my Directed Automobile Electronics?
The diagnostic data bus wasn't detected, so the SmartStart features will be limited.
What does PTS shutdown error mean on Directed Automobile Electronics?
The PTS output from the module wasn't activated due to safety protection.
General| Brand | Directed |
|---|---|
| Model | Directechs DB3 |
| Category | Automobile Accessories |
| Language | English |
Lists all functions compatible with the vehicle for installation.
Presents an alternative wiring diagram for the DB3 module installation.
Shows alternative locations of key components within the vehicle for installation.
Lists error codes indicated by LED flashes during module programming.
Addresses troubleshooting for OBDII features and external module sync issues.
Explains LED feedback for lock, unlock, trunk, and auxiliary commands received.
Lists LED indicators for various reasons of remote start unscheduled shutdown.
Explains LED indicators for Remote Start Ready (RSR) specific error conditions.
Describes methods to send commands like lock, unlock, and remote start.
Explains the "Get In and Go" feature for seamless takeover after remote start.
Explains the functionality and benefits of the SmartStart mobile application for vehicle control.
