M
moralesrandySep 18, 2025
What to do if Directed Automobile Electronics CAN bus incorrectly detected?
- AAlan JohnsonSep 18, 2025
Verify the CAN1 and CAN2 connections.
To Next PageTo Next PageWhat to do if Directed Automobile Electronics CAN bus incorrectly detected?
Verify the CAN1 and CAN2 connections.
Why speed was detected on Directed Automobile Accessories?
If speed was detected by your Directed Automobile Accessories, it means the vehicle was detected as moving, which prevents the system from shutting it down.
What to do if Directed Door locks module has no power?
First, check the D2D harness connection and ensure there's 12 Volts between the red and black wires. If the voltage is correct, the Directed Door locks module itself might be defective.
What to do if Directed Door locks CAN1 not detected?
Check the CAN1 Tan and Tan/Black wire connections. Try waking up the data bus by turning the ignition on and trying again. If your installation doesn't need this connection, skip it by pressing the programming button 5 times.
What to do if Directed Door locks CAN2 not detected?
Check the CAN2 Orange/Green and Orange/Brown wire connections. Wake up the data bus by turning the ignition on and try again. If your installation does not require this connection, skip this step by pressing the programming button 5 times.
What to do if Directed Door locks J1850 not detected?
Check the J1850 wire connection. Wake up the data bus by turning the ignition on and try again.
What to do if Directed Door locks bypass processing error?
The bypass calculation has failed. Reset the Directed Door locks module and try again.
What does it mean if Directed Door locks transponder functions were skipped?
If RXT mode is not desired or convenience features are needed (if compatible), reset and reprogram the Directed Door locks module.
What does it mean if Directed Directechs DB3 says MUX not detected?
If the Directed Automobile Accessories system indicates 'MUX not detected', the Violet/Green or Violet/Brown wire did not detect the expected voltage value. Refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
Why Directed Directechs DB3 transponder functions were skipped?
General| Brand | Directed |
|---|---|
| Model | Directechs DB3 |
| Category | Automobile Accessories |
| Language | English |
Lists all functions compatible with the vehicle for installation.
Presents an alternative wiring diagram for the DB3 module installation.
Shows alternative locations of key components within the vehicle for installation.
Lists error codes indicated by LED flashes during module programming.
Addresses troubleshooting for OBDII features and external module sync issues.
Explains LED feedback for lock, unlock, trunk, and auxiliary commands received.
Lists LED indicators for various reasons of remote start unscheduled shutdown.
Explains LED indicators for Remote Start Ready (RSR) specific error conditions.
Describes methods to send commands like lock, unlock, and remote start.
Explains the "Get In and Go" feature for seamless takeover after remote start.
Explains the functionality and benefits of the SmartStart mobile application for vehicle control.
