To Next PageTo Next PageWhat to do if Directed Automobile Accessories says MUX not detected?
The Violet/Green or Violet/Brown wire did not detect the expected voltage value. Refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
What to do if Directed Automobile Electronics CAN bus incorrectly detected?
Verify the CAN1 and CAN2 connections.
What does feature error mean for Directed Directechs DB3 Automobile Accessories?
If you are experiencing a feature error with your Directed Automobile Accessories, an RSR feature file mismatch was detected. Please contact Technical Support.
What to do if Directed Directechs DB3 Automobile Accessories bypass data is not detected?
Check the connection of the bypass line. If multiple wires are used, ensure they are not inverted. Also, verify that the vehicle operates correctly with the factory key.
What to do if CAN1 is not detected in Directed Directechs DB3 Automobile Accessories?
Check the connections of the CAN1 Tan and Tan/Black wires. Then, wake up the data bus by turning the ignition on and try again. If your installation doesn't need this connection, skip this step by pressing the programming button 5 times.
What does feature error mean on Directed Directechs DB3 Automobile Accessories?
An RSR feature file mismatch was detected for your Directed Automobile Accessories. Please contact Technical Support.
What to do if my Directed Automobile Accessories system displays 'Bypass processing error'?
The bypass calculation failed. Reset the Directed Automobile Accessories module and try again. If the condition persists, please contact Technical Support.
Why Directed Remote Starter PTS shutdown error?
The PTS output from the module was not activated due to safety protection.
What does it mean if Directed Directechs DB3 shows PTS shutdown error?
The PTS output from the module was not activated due to safety protection.
What to do if CAN2 is not detected in Directed Automobile Electronics?
If CAN2 isn't being detected, check the connections of the Orange/Green and Orange/Brown wires. Try waking up the data bus by turning the ignition on and trying again. If your installation does not require this connection, skip this step by pressing the programming button 5 times.
General| Brand | Directed |
|---|---|
| Model | Directechs DB3 |
| Category | Automobile Accessories |
| Language | English |
Lists all functions compatible with the vehicle for installation.
Presents an alternative wiring diagram for the DB3 module installation.
Shows alternative locations of key components within the vehicle for installation.
Lists error codes indicated by LED flashes during module programming.
Addresses troubleshooting for OBDII features and external module sync issues.
Explains LED feedback for lock, unlock, trunk, and auxiliary commands received.
Lists LED indicators for various reasons of remote start unscheduled shutdown.
Explains LED indicators for Remote Start Ready (RSR) specific error conditions.
Describes methods to send commands like lock, unlock, and remote start.
Explains the "Get In and Go" feature for seamless takeover after remote start.
Explains the functionality and benefits of the SmartStart mobile application for vehicle control.
