To Next PageTo Next PageWhat to do if CAN1 is not detected in Directed Directechs DB3 Automobile Accessories?
Check the connections of the CAN1 Tan and Tan/Black wires. Then, wake up the data bus by turning the ignition on and try again. If your installation doesn't need this connection, skip this step by pressing the programming button 5 times.
What causes bypass processing error in Directed Directechs DB3 Automobile Accessories?
If you encounter a bypass processing error with your Directed Automobile Accessories, reset the module and try again. If the condition persists, please contact Technical Support.
What to do for Directed Directechs DB3 bypass processing error?
If your Directed Automobile Accessories module shows a bypass processing error, it means the bypass calculation failed. Try resetting the module and attempting the process again. If the problem persists, further assistance may be required.
What does feature error mean on Directed Directechs DB3 Automobile Accessories?
An RSR feature file mismatch was detected for your Directed Automobile Accessories. Please contact Technical Support.
What to do if Directed Automobile Accessories says MUX not detected?
The Violet/Green or Violet/Brown wire did not detect the expected voltage value. Refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
What to do if ISO 1 is not detected in Directed Directechs DB3 Automobile Accessories?
The Yellow/Black wire did not detect the expected signal. Check the connections.
What to do if ISO 2 is not detected in Directed Automobile Accessories?
The Orange/Black wire did not detect the expected signal. Check the connections.
What to do if MUX is not detected in Directed Directechs DB3?
The Violet/Green or Violet/Brown wire did not detect the expected voltage value. Check the connections.
What to do if Directed Remote Starter feature error?
An RSR feature file mismatch was detected. Please contact Technical Support.
Why Runsafe was not disabled in Directed Directechs DB3?
No UNLOCK command was received prior to opening the door, or the 45 second timer expired in takeover mode.
General| Brand | Directed |
|---|---|
| Model | Directechs DB3 |
| Category | Automobile Accessories |
| Language | English |
Lists all functions compatible with the vehicle for installation.
Presents an alternative wiring diagram for the DB3 module installation.
Shows alternative locations of key components within the vehicle for installation.
Lists error codes indicated by LED flashes during module programming.
Addresses troubleshooting for OBDII features and external module sync issues.
Explains LED feedback for lock, unlock, trunk, and auxiliary commands received.
Lists LED indicators for various reasons of remote start unscheduled shutdown.
Explains LED indicators for Remote Start Ready (RSR) specific error conditions.
Describes methods to send commands like lock, unlock, and remote start.
Explains the "Get In and Go" feature for seamless takeover after remote start.
Explains the functionality and benefits of the SmartStart mobile application for vehicle control.
