M
Melissa ThompsonSep 14, 2025
Why Directed Remote Starter OBDII feature not supported?
- FfadamsSep 14, 2025
The diagnostic data bus was not detected, therefore the SmartStart features will be limited.
To Next PageTo Next PageWhy Directed Remote Starter OBDII feature not supported?
The diagnostic data bus was not detected, therefore the SmartStart features will be limited.
What does it mean if Directed Directechs DB3 says MUX not detected?
If the Directed Automobile Accessories system indicates 'MUX not detected', the Violet/Green or Violet/Brown wire did not detect the expected voltage value. Refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
What to do if MUX is not detected in Directed Directechs DB3?
The Violet/Green or Violet/Brown wire did not detect the expected voltage value. Check the connections.
What does 'RFTD disabled' mean in Directed Automobile Accessories?
If the Directed Automobile Accessories system indicates 'RFTD disabled,' 3x OEM Lock Remote Start Activation was attempted when the RFTD feature is disabled. Make sure 3x Lock Start is selected from the web in the flashing process.
What to do if ISO 1 is not detected in Directed Directechs DB3 Automobile Accessories?
The Yellow/Black wire did not detect the expected signal. Check the connections.
Why is the smart key not detected by my Directed Directechs DB3?
The smart key was not detected, which prevents the system from shutting down the vehicle.
What does Directed Automobile Accessories stop fail mean?
The RXT start/stop message was received by the module, but not executed on the vehicle.
What to do if Directed Remote Starter feature error?
An RSR feature file mismatch was detected. Please contact Technical Support.
What to do if Directed Remote Starter J1850 not detected?
Check the J1850 wire connection. Wake up the data bus by turning the ignition on and try again.
What to do if CAN1 is not detected in Directed Directechs DB3 Automobile Accessories?
Check the connections of the CAN1 Tan and Tan/Black wires. Then, wake up the data bus by turning the ignition on and try again. If your installation doesn't need this connection, skip this step by pressing the programming button 5 times.
General| Brand | Directed |
|---|---|
| Model | Directechs DB3 |
| Category | Automobile Accessories |
| Language | English |
Lists all functions compatible with the vehicle for installation.
Presents an alternative wiring diagram for the DB3 module installation.
Shows alternative locations of key components within the vehicle for installation.
Lists error codes indicated by LED flashes during module programming.
Addresses troubleshooting for OBDII features and external module sync issues.
Explains LED feedback for lock, unlock, trunk, and auxiliary commands received.
Lists LED indicators for various reasons of remote start unscheduled shutdown.
Explains LED indicators for Remote Start Ready (RSR) specific error conditions.
Describes methods to send commands like lock, unlock, and remote start.
Explains the "Get In and Go" feature for seamless takeover after remote start.
Explains the functionality and benefits of the SmartStart mobile application for vehicle control.
