E
Erin WashingtonSep 9, 2025
Why is there a PTS shutdown error in my Directed Directechs DB3 Automobile Accessories?
- SStephen NelsonSep 10, 2025
The PTS output from the module was not activated due to safety protection.
To Next PageTo Next PageWhy is there a PTS shutdown error in my Directed Directechs DB3 Automobile Accessories?
The PTS output from the module was not activated due to safety protection.
Why Directed Directechs DB3 speed was detected?
The vehicle was detected as moving, which prevents the system from shutting it down.
What does PTS shutdown error mean on Directed Automobile Electronics?
The PTS output from the module wasn't activated due to safety protection.
What to do if MUX is not detected in Directed Directechs DB3?
The Violet/Green or Violet/Brown wire did not detect the expected voltage value. Check the connections.
What to do if ISO 2 is not detected in Directed Automobile Accessories?
The Orange/Black wire did not detect the expected signal. Check the connections.
What to do if ISO 1 is not detected in Directed Directechs DB3 Automobile Accessories?
The Yellow/Black wire did not detect the expected signal. Check the connections.
What causes bypass processing error in Directed Directechs DB3 Automobile Accessories?
If you encounter a bypass processing error with your Directed Automobile Accessories, reset the module and try again. If the condition persists, please contact Technical Support.
What does it mean when my Directed Directechs DB3 says 'Waiting to begin the programming sequence'?
This indicates that you should ensure the correct programming procedure is being followed for your Directed Automobile Accessories system.
Why Runsafe was not disabled in Directed Directechs DB3?
No UNLOCK command was received prior to opening the door, or the 45 second timer expired in takeover mode.
What to do if Directed Remote Starter J1850 not detected?
Check the J1850 wire connection. Wake up the data bus by turning the ignition on and try again.
General| Brand | Directed |
|---|---|
| Model | Directechs DB3 |
| Category | Automobile Accessories |
| Language | English |
Lists all functions compatible with the vehicle for installation.
Presents an alternative wiring diagram for the DB3 module installation.
Shows alternative locations of key components within the vehicle for installation.
Lists error codes indicated by LED flashes during module programming.
Addresses troubleshooting for OBDII features and external module sync issues.
Explains LED feedback for lock, unlock, trunk, and auxiliary commands received.
Lists LED indicators for various reasons of remote start unscheduled shutdown.
Explains LED indicators for Remote Start Ready (RSR) specific error conditions.
Describes methods to send commands like lock, unlock, and remote start.
Explains the "Get In and Go" feature for seamless takeover after remote start.
Explains the functionality and benefits of the SmartStart mobile application for vehicle control.
