A
andrea66Sep 6, 2025
What does Directed Automobile Accessories stop fail mean?
- JJeffrey CarlsonSep 6, 2025
The RXT start/stop message was received by the module, but not executed on the vehicle.
To Next PageTo Next PageTo Previous PageTo Previous Page
Loading...What does Directed Automobile Accessories stop fail mean?
The RXT start/stop message was received by the module, but not executed on the vehicle.
Why is my Directed Automobile Accessories module not getting power?
First, ensure the D2D harness is properly connected and verify that 12 Volts are present between the red and black wires. If the voltage is correct and the Directed Automobile Accessories module still has no power, it may be defective.
What does it mean if Directed Directechs DB3 says MUX not detected?
If the Directed Automobile Accessories system indicates 'MUX not detected', the Violet/Green or Violet/Brown wire did not detect the expected voltage value. Refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
What to do if Directed Automobile Electronics shows a bypass processing error?
If you encounter a bypass calculation failure, reset the module and try again.
What to do if Directed Remote Starter initialization failed?
Reset the module and complete the programming again. If the issue persists, please contact Technical Support.
What does it mean if Directed Door locks transponder functions were skipped?
If RXT mode is not desired or convenience features are needed (if compatible), reset and reprogram the Directed Door locks module.
What to do if my Directed Automobile Accessories system displays 'Bypass processing error'?
The bypass calculation failed. Reset the Directed Automobile Accessories module and try again. If the condition persists, please contact Technical Support.
What does it mean when my Directed Directechs DB3 says 'Waiting to begin the programming sequence'?
This indicates that you should ensure the correct programming procedure is being followed for your Directed Automobile Accessories system.
What to do if my Directed Directechs DB3 Automobile Accessories system says 'Initialization failed'?
Reset the Directed Automobile Accessories module and complete the programming again. If the issue persists, please contact Technical Support.
What to do if my Directed Automobile Accessories system shows 'ISO 1 not detected'?
The Yellow/Black wire did not detect the expected signal. Refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
General| Brand | Directed |
|---|---|
| Model | Directechs DB3 |
| Category | Automobile Accessories |
| Language | English |
Lists all functions compatible with the vehicle for installation.
Presents an alternative wiring diagram for the DB3 module installation.
Shows alternative locations of key components within the vehicle for installation.
Lists error codes indicated by LED flashes during module programming.
Addresses troubleshooting for OBDII features and external module sync issues.
Explains LED feedback for lock, unlock, trunk, and auxiliary commands received.
Lists LED indicators for various reasons of remote start unscheduled shutdown.
Explains LED indicators for Remote Start Ready (RSR) specific error conditions.
Describes methods to send commands like lock, unlock, and remote start.
Explains the "Get In and Go" feature for seamless takeover after remote start.
Explains the functionality and benefits of the SmartStart mobile application for vehicle control.
