M
Miss Jessica WilliamsSep 6, 2025
Why Directed Directechs DB3 speed was detected?
- RRyan SchultzSep 6, 2025
The vehicle was detected as moving, which prevents the system from shutting it down.
To Next PageTo Next PageTo Previous PageTo Previous Page
Loading...Why Directed Directechs DB3 speed was detected?
The vehicle was detected as moving, which prevents the system from shutting it down.
What to do if ISO 1 is not detected in Directed Directechs DB3 Automobile Accessories?
The Yellow/Black wire did not detect the expected signal. Check the connections.
What does ISO 2 not detected mean for Directed Directechs DB3 Automobile Accessories?
If ISO 2 is not being detected by your Directed Automobile Accessories, it means the Orange/Black wire didn't detect the expected signal. Refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
What does 'Runsafe was not disabled' mean on my Directed Automobile Accessories?
No UNLOCK command was received prior to opening the door, or the 45 second timer expired in takeover mode.
What to do if my Directed Automobile Accessories system displays 'Bypass processing error'?
The bypass calculation failed. Reset the Directed Automobile Accessories module and try again. If the condition persists, please contact Technical Support.
Why was the smart key not detected by Directed Automobile Accessories?
The smart key was not detected, which prevents the system from shutting down the vehicle.
What to do if Directed Directechs DB3 Automobile Accessories is waiting to begin the programming sequence?
Make sure you are following the correct programming procedure.
What to do if Directed Directechs DB3 Automobile Accessories says CAN2 not detected?
Check the CAN2 Orange/Green and Orange/Brown wire connections. Wake up the data bus by turning the ignition on and try again. If your installation does not require this connection, skip this step by pressing the programming button 5 times.
What does 'RFTD disabled' mean in Directed Automobile Accessories?
If the Directed Automobile Accessories system indicates 'RFTD disabled,' 3x OEM Lock Remote Start Activation was attempted when the RFTD feature is disabled. Make sure 3x Lock Start is selected from the web in the flashing process.
What does it mean if Directed Directechs DB3 says MUX not detected?
If the Directed Automobile Accessories system indicates 'MUX not detected', the Violet/Green or Violet/Brown wire did not detect the expected voltage value. Refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
General| Brand | Directed |
|---|---|
| Model | Directechs DB3 |
| Category | Automobile Accessories |
| Language | English |
Lists all functions compatible with the vehicle for installation.
Presents an alternative wiring diagram for the DB3 module installation.
Shows alternative locations of key components within the vehicle for installation.
Lists error codes indicated by LED flashes during module programming.
Addresses troubleshooting for OBDII features and external module sync issues.
Explains LED feedback for lock, unlock, trunk, and auxiliary commands received.
Lists LED indicators for various reasons of remote start unscheduled shutdown.
Explains LED indicators for Remote Start Ready (RSR) specific error conditions.
Describes methods to send commands like lock, unlock, and remote start.
Explains the "Get In and Go" feature for seamless takeover after remote start.
Explains the functionality and benefits of the SmartStart mobile application for vehicle control.
