M
Mrs. Shelby GonzalezSep 8, 2025
What does PTS shutdown error mean on Directed Control Unit?
- GgarcianatalieSep 8, 2025
The PTS output from the module was not activated due to safety protection.
To Next PageTo Next PageWhat does PTS shutdown error mean on Directed Control Unit?
The PTS output from the module was not activated due to safety protection.
Why smart key was not detected on Directed Control Unit?
The smart key was not detected, which prevents the system from shutting down the vehicle.
Why speed was detected on Directed Control Unit?
The vehicle was detected as moving, which prevents the system from shutting it down.
What to do if transponder functions were skipped on Directed Control Unit?
(If compatible) when RXT mode is not desired or convenience features are needed, please reset the and reprogram the module.
How to fix Directed VOXX DEI DS3+ Automobile Accessories module if it has no power?
If the Directed automobile accessory module has no power, ensure the D2D harness is connected and that there is 12 Volts present between the red and black wires. If 12 Volts is present, it's possible the module is defective.
What to do if CAN1 is not detected in Directed VOXX DEI DS3+ Automobile Accessories?
If CAN1 is not detected by your Directed Automobile Accessories, check the CAN1 Tan and Tan/Black wire connections. Try waking up the data bus by turning the ignition on and trying again. If your installation does not require this connection, you can skip this step by pressing the programming button 5 times.
What to do if J1850 is not detected in Directed Automobile Accessories?
If J1850 is not detected by your Directed Automobile Accessories, check the J1850 wire connection. You can also try waking up the data bus by turning the ignition on and trying again.
What does it mean if OBDII feature is not supported in Directed VOXX DEI DS3+ Automobile Accessories?
If the OBDII feature is not supported in your Directed Automobile Accessories, the diagnostic data bus was not detected, therefore the SmartStart features will be limited.
What causes PTS shutdown error in Directed VOXX DEI DS3+?
If the Directed Automobile Accessories experiences a PTS shutdown error, it means that the PTS output from the module was not activated due to safety protection.
What to do if ISO 1 is not detected in Directed VOXX DEI DS3+ Automobile Accessories?
If the ISO 1 is not detected in your Directed Automobile Accessories because the Yellow/Black wire did not detect the expected signal, check the connections using the 'Installation (wiring diagrams & vehicle wiring reference charts)'.
General| Brand | Directed |
|---|---|
| Model | VOXX DEI DS3+ |
| Category | Automobile Accessories |
| Language | English |
