What to do if CAN2 is not detected on Directed Remote Starter?
Check the connections of the CAN2 Orange/Green and Orange/Brown wires. Wake up the data bus by turning the ignition on and try again. If your installation does not require this connection, skip this step by pressing the programming button 5 times.
What to do if Directed VOXX DEI DS3+ Automobile Accessories ISO 1 not detected?
If the Yellow/Black wire did not detect the expected signal, refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
What does it mean if Directed VOXX DEI DS3+ PTS shutdown error?
The PTS output from the module was not activated due to safety protection.
What to do if there is a bypass processing error on Directed Control Unit?
Reset the module and try again. If the condition persists, please contact Technical Support.
What to do if Directed VOXX DEI DS3+ Automobile Accessories transponder functions were skipped?
If compatible and when RXT mode is not desired or convenience features are needed, reset and reprogram the module.
What to do if Directed VOXX DEI DS3+ Automobile Accessories says CAN1 not detected?
If the Directed Automobile Accessories module reports that CAN1 is not detected, check the connections of the CAN1 Tan and Tan/Black wires. You can try to wake up the data bus by turning the ignition on and trying again. If your installation doesn't need this connection, you can skip this step by pressing the programming button 5 times.
Why smart key was not detected on Directed Control Unit?
The smart key was not detected, which prevents the system from shutting down the vehicle.
What to do if Directed Remote Starter is waiting to begin the programming sequence?
Make sure that you are following the correct programming procedure.
What does 'Bypass processing error' mean for Directed Automobile Accessories?
The bypass calculation failed. Reset the module and try again. If the condition persists, please contact Technical Support.
What to do if CAN2 is not detected on Directed VOXX DEI DS3+?
Check the CAN2 Orange/Green and Orange/Brown wire connections. Wake up the data bus by turning the ignition on and try again. If your installation does not require this connection, skip this step by pressing the programming button 5 times.
General| Brand | Directed |
|---|---|
| Model | VOXX DEI DS3+ |
| Category | Automobile Accessories |
| Language | English |
To Next Page