Directed VOXX DEI DS3+ - User Manual

37 pages

Save Page as PDF

To Next Page

Functions compatible with the 2022 Honda HR-V (Smart Key)

*Telematics features: The telematics features listed below (with an asterisk) ONLY apply when using SmartStart Pro.

* Odometer

3x LOCK START (Start control using OEM Remote)

3x LOCK STOP (Stop control using OEM Remote)

Accessory Activation

Arm Factory Security

Brake Status (foot brake)

Control of aftermarket alarm with OEM remote

Disarm Factory Security

Door Lock Control

Door Locks Status

Door Unlock

Driver Priority Unlock

E-Brake Status

Entry Monitoring ALL Door Pins

Entry Monitoring Hood Pin

Entry Monitoring Trunk/Hatch Pin

Factory Alarm Trigger Monitoring

Fuel level/EV battery level

Ignition Activation

Ignition Status

Immobilizer Bypass-Data No Key Req'd

Key2GO

RAP Shut Down (Retained ACC Power)

Remote Start Takeover

SmartStart

Start (Crank) Activation

Tach / RPM Output

Trunk / Hatch Release

933.HONDA9

v2.10.198.12

2022 Honda HR-V (Smart Key)

THHON11, THHON1-NO-TAKEOVER, THHON9-

TAKEOVER Compatible

(Sold Separately)

Main Page

Questions and Answers

D
david26Aug 27, 2025
What to do if Directed VOXX DEI DS3+ Automobile Accessories bypass data not detected?
- T
  Todd RamseyAug 27, 2025
  Check the bypass line connection. If there's more than one wire, ensure they aren't inverted. Also, make sure the vehicle still operates correctly using the factory key.
S
Stephanie StevensSep 22, 2025
Why is the CAN bus incorrectly detected in my Directed Remote Starter?
- P
  Patricia GarrettSep 22, 2025
  Verify the CAN1 and CAN2 connections.
M
Michael ReedSep 12, 2025
What to do if transponder functions were skipped on my Directed Remote Starter?
- B
  Brandon MoyerSep 12, 2025
  If transponder functions were skipped on your Directed Remote Starter, and if compatible, when the RXT mode is not desired or convenience features are needed, reset and reprogram the module.
S
Sherry StephensonSep 15, 2025
Why Directed VOXX DEI DS3+ OBDII feature is not supported?
- A
  Aaron HarrisSep 15, 2025
  The diagnostic data bus was not detected, therefore the SmartStart features will be limited in your Directed Automobile Accessories.
K
kimryanSep 15, 2025
What to do if Directed VOXX DEI DS3+ has DEI feature error?
- J
  Jennifer GardnerSep 15, 2025
  Please contact Technical Support if you encounter a DEI feature error with your Directed Automobile Accessories.
T
Taylor SanchezSep 4, 2025
What causes a bypass processing error in Directed VOXX DEI DS3+?
- D
  Devin MirandaSep 4, 2025
  Reset the module and try again. If the condition persists, please contact Technical Support.
J
James BrownAug 28, 2025
What to do if Directed VOXX DEI DS3+ Automobile Accessories transponder functions were skipped?
- S
  Shannon MontgomeryAug 28, 2025
  If compatible and when RXT mode is not desired or convenience features are needed, reset and reprogram the module.
T
Timothy RomeroAug 28, 2025
Why is Directed VOXX DEI DS3+ Automobile Accessories showing 'Speed was detected'?
- C
  Christopher KirbyAug 28, 2025
  The vehicle was detected as moving, which prevents the system from shutting it down.
D
David MoodyAug 28, 2025
What does it mean if Directed VOXX DEI DS3+ PTS shutdown error?
- C
  cassandrachavezAug 29, 2025
  The PTS output from the module was not activated due to safety protection.
J
Jessica PenningtonSep 22, 2025
What to do if Directed Remote Starter is waiting to begin the programming sequence?
- L
  luis44Sep 22, 2025
  Make sure that you are following the correct programming procedure.