To Next PageTo Next PageHow to troubleshoot Directed Control Unit when module has no power?
Make sure the D2D harness is connected and that 12 Volt is present between the red and black wires. If 12 Volt is present, the module may be defective.
What causes a bypass processing error in Directed VOXX DEI DS3+?
Reset the module and try again. If the condition persists, please contact Technical Support.
How to fix CAN1 not detected error in Directed VOXX DEI DS3+?
The CAN1 Tan and Tan/Black wire connections need to be checked. Try waking up the data bus by turning the ignition on and trying again. If your installation doesn't need this connection, you can skip this step by pressing the programming button 5 times.
What to do if Directed Automobile Accessories module has no power?
First, ensure the D2D harness is connected and that there's 12V present between the red and black wires. If 12V is present, the module might be defective.
What to do if CAN1 is not detected on Directed VOXX DEI DS3+ Automobile Accessories?
Check the CAN1 Tan and Tan/Black wire connections. Wake up the data bus by turning the ignition on and try again. If your installation does not require this connection, skip this step by pressing the programming button 5 times.
What to do if Directed VOXX DEI DS3+ Automobile Accessories bypass data not detected?
Check the bypass line connection. If there's more than one wire, ensure they aren't inverted. Also, make sure the vehicle still operates correctly using the factory key.
What to do if Directed VOXX DEI DS3+ has bypass processing error?
Reset the Directed Automobile Accessories module and try again. If the condition persists, please contact Technical Support.
What does it mean if OBDII feature is not supported in Directed VOXX DEI DS3+ Automobile Accessories?
If the OBDII feature is not supported in your Directed Automobile Accessories, the diagnostic data bus was not detected, therefore the SmartStart features will be limited.
What to do if my Directed Remote Starter shows CAN2 not detected?
If your Directed Remote Starter displays a 'CAN2 not detected' message, check the connections of the CAN2 Orange/Green and Orange/Brown wires. Wake up the data bus by turning the ignition on and try again. If the installation doesn't require this connection, skip this step by pressing the programming button 5 times.
Why is the OBDII feature not supported on my Directed VOXX DEI DS3+?
The diagnostic data bus was not detected, so the SmartStart features will be limited.
General| Brand | Directed |
|---|---|
| Model | VOXX DEI DS3+ |
| Category | Automobile Accessories |
| Language | English |
