33
2 Functionality
GB
2 Functionality
2.1 Mode of operation
With the "Fusion" robot vacuum cleaner you
have purchased a robot vacuum cleaner
which runs fully automatically.
Your robot follows the following cleaning pat-
tern (Fig. 4):
"Random mode" Z "gyro mode" Z "edge
mode" Z "gyro mode" Z "snake mode" Z "gy-
ro mode" Z "random mode"
If the appliance does not switch off at the end
of this cycle, the cycle starts again.
This programme sequence makes for seam-
less cleaning with overlapping paths. For this
to work, the room must not be too large and
the appliance must not run into an obstacle
too early in "gyro mode".
If the appliance encounters an obstacle in "gy-
ro mode", it immediately switches to "edge
mode".
2.2 Fall safeguard
With the aid of 3 fall sensors, your robot vac-
uum automatically detects drop-offs in front of
it (Fig. 5). If a drop-off is detected it changes
its direction of travel and continues to clean in
the opposite direction.
Lower-level surfaces, such as stairs are de-
tected and thus omitted from the cleaning.
You can adjust the sensitivity of the fall sen-
sors, ZChapter 7.1, ‘Adjusting the sensitivity
of the fall sensors’.
M611.book Seite 33 Donnerstag, 2. Juli 2015 8:54 08
To Next Page
Loading...
