14
Displaying Device Code
To identify the device code that your remote control
is using, complete the following steps:
Press and hold the Mode
button until all the Mode
buttons light up and then
release it. When you
release the Mode button,
the selected Mode button
ashes.
Press and release POUND
(#) twice.
The Mode button ashes
a number of times
corresponding to the value of
the stored device code. For
example, if the stored device
code is 593, the Mode button
ashes ve times, pauses,
ashes nine times, pauses,
and ashes three times. A
quick ash is for zero.
For AUX mode: The rst group
of ashes tells you what the AUX
mode controls, then the following
ashes tell you each digit of the
device’s code.
Record the stored device
code in the Reference Table
on the inside back cover.
3
2
1
4
To Next Page
Loading...
