Drill - 60 Cx Series Operator’s Manual
Set Up
Install Drill String
1. Check condition and function of equipment:
• Ensure rod sections are not bent.
• Ensure slip latches are functioning properly.
• Ensure bits are in good condition.
2. Assemble at least 20’ (6m), but no more than 30’ (9m), of drill rod.
3. Install drill bit.
4. Put drill string in approach trench.
5. Start engine.
6. Align machine with drill string and intended bore path.
7. Shut off machine.
8. Attach drill string to drilling attachment.
NOTICE: Incorrect installation can cause rod sections to bend. Ensure at least half of drill string
length is inside trench.
To Next Page
Loading...
