Service - 84 Cx Series Operator’s Manual
Procedures
Procedures
Battery
Check battery every 10 hours. Charge as needed.
Corrosive fluid. Contact can cause death or serious injury.
Avoid contact. Wear appropriate gloves. See Safety Data Sheet (SDS) for
more information.
To help avoid injury:
• Never attempt to charge a battery that is leaking, bulging, heavily corroded, frozen, or otherwise
damaged.
• Refer to Safety Data Sheet (SDS) for additional information regarding battery.
Explosive hydrogen gas. Fire or explosion can cause death
or serious injury. Keep heat flames, sparks, and other sources of ignition
away.
To help avoid injury:
• Use a single 12V maximum source for charging. Never connect to rapid chargers or dual batteries.
• Never lean over battery when making connections.
• Never allow vehicles to touch when charging.
• Never short-circuit battery terminals for any reason or strike battery posts or cable terminals.
• Refer to Safety Data Sheet (SDS) for additional information regarding battery.
NOTICE:
• Electronic components can be easily damaged by electrical surges. Jump starting can damage
electronics and electrical systems, and is not recommended. Try to charge the battery instead. Use
quality large diameter jumper cables capable of carrying high currents (400 amps or more). Low
quality cables may not allow enough current flow to charge a dead/discharged battery.
• Read all steps thoroughly and review illustration before performing procedure.
To Next Page
Loading...
Need help?
General
