Transport - 66 JT520 Operator’s Manual
Haul
CMW
Haul
Load
1. Start drilling unit engine.
2. Move drilling unit to rear of trailer and align with ramps.
3. Slow engine to low throttle and slowly drive unit onto trailer.
4. Lower stabilizer to trailer floor.
5. Stop engine when unit is safely positioned on trailer bed.
6. Attach tiedowns to drilling unit where indicated on page 67.
Crushing weight. If load falls or moves it could kill or crush you. Use
proper procedures and equipment or stay away.
NOTICE:
• Load and unload trailer on level ground.
• Verify that trailer wheels are blocked.
• Incorrect loading can cause trailer swaying.
• Attach trailer to vehicle before loading or unloading.
• Ten to fifteen percent of total vehicle weight (equipment plus trailer) must be on tongue to help
prevent trailer sway.
To Next Page
Loading...
