Controls - 30 XT855 Operator’s Manual
Joysticks
CMW
4. Left joystick With work mode switch in
tool carrier mode:
• To move forward, push.
• To move backward, pull.
• To go faster in either
direction, move farther
from neutral.
• To stop, return to neutral.
IMPORTANT:
• Control can perform more than
one action at a time. Using them
together, operator can “feather” or
combine operations.
• For steering instructions, see
page 48.
With work mode switch in
excavator mode:
• To swing excavator to
right, move right.
• To swing excavator to left,
move left.
• To raise boom, pull.
• To lower boom, push.
IMPORTANT: SAE excavator control
pattern is shown. For information
about ISO control pattern, see
page 68.
5. Boom offset switch To swing boom to right, press
right side.
To swing boom to left, press
left side.
Item Description Notes
c00ic224h.eps
SAE
c00ic219h.eps
c00ic227h.eps
To Next Page
Loading...
