19
IP2162EN
EN
Display Description
OB - Adjustment of deceleration distance during
closing. [cm]
Indicates the distance from the end of the closing
stroke where the deceleration ramp begins.
05 - Minimum , (20 - Neos Super Fast)
99 - Maximum
N.B.: reduce the deceleration space if there is a series
of quick vibrations (chattering) in heavy gates installed
with a slight incline.
40
Neos Super Fast
99
PO - Adjustment of approach speed during opening.
[cm/s]
Indicates the speed from the end of the deceleration
ramp to the end of the stroke.
02 - Minimum
10 - Maximum
N.B.: gradually increase the approach speed if there is
a series of quick vibrations (chattering) in heavy gates
installed with a slight incline.
03
05
(Neos Super Fast)
PC - Adjustment of approach speed during closing.
[cm/s]
Indicates the speed from the end of the deceleration
ramp to the end of the stroke.
02 - Minimum
10 - Maximum
N.B.: gradually increase the approach speed if there is
a series of quick vibrations (chattering) in heavy gates
installed with a slight incline.
03
05
(Neos Super Fast)
OO - Obstacle detection limit during opening [cm]
Indicates the distance from the end of the opening
stroke after which each obstacle is considered a stop.
05 - Minimum
99 - Maximum
N.B.: This parameter is only active if → →
40
OC - Obstacle detection limit during closing [cm]
Indicates the distance from the end of the closing
stroke after which each obstacle is considered a stop.
05 - Minimum
99 - Maximum
N.B.: This parameter is only active if → →
40
i
N.B.: make adjustments gradually and only after performing at least three complete
operations to allow the control panel to be set correctly and detect any friction during
operations.
BA
To Next Page
Loading...