Ditec Entrematic CS12E - Safety Devices and Commands Display

33
IP2162EN
EN
8.2 Display of safety devices and commands
i
The safety device and command display mode is only visible with Display visualisation
mode set to 01 or 03.
Display Description
1-3 - Opening command.
1-4 - Closing command.
1-5 - Step-by-step command.
1-6 - Safety device with opening and closing stop.
1-8 - Safety with closing reversal.
P3 - Partial opening command.
3P - Opening command with operator present.
4P - Closing command with operator present.
RX - Radio reception (of any memorised key of a transmitter present
in the memory).
NX - Radio reception (of any non-memorised key).
EX - Rolling-code radio reception out of sequence
EP - Radio reception not complying with the parameter configuration
→
→ →
→ →