IP1529EN
ASSA ABLOY Entrance Systems AB
Lodjursgatan 10
SE-261 44, Landskrona
Sweden
© ASSA ABLOY
C
B
D
In the event of a fault or an interruption in the
power supply, insert the key supplied [C] and turn
it anticlockwise, or move the lever [D] as shown in
the figure.
Move the tilting door manually.
To block the up and over door again, bring the lever
[D] back to its original position.
Manual release instructions
WARNING: the door wing block and release
operations must be performed with the mo-
tor idle.
NOTE: The gearmotor can also be released
using the BOXSBC accessories.
For more information, refer to the relevant
installation manuals.
Installer's stamp Operator
Date of intervention
Technician's signature
Customer's signature
Intervention performed
For any problems and/or information, contact the Technical Service.
All the rights concerning this material are the exclusive property of ASSA ABLOY Entrance Systems AB. Although
the contents of this publication have been drawn up with the greatest care, ASSA ABLOY Entrance Systems AB
cannot be held responsible in any way for any damage caused by mistakes or omissions in this publication.
We reserve the right to make changes without prior notice.
Copying, scanning or changing in any way is expressly forbidden unless authorised in writing by ASSA ABLOY
Entrance Systems AB.
The crossed-out wheelie bin symbol indicates that the product should be disposed of separately from
normal household waste. The product should be recycled in accordance with local environmental regula-
tions for waste disposal. By separating a product marked with this symbol from household waste, you will
help reduce the volume of waste sent to incinerators or land-fill and minimise any potential negative impact on
human health and the environment.
To Previous Page
Loading...
